Exterior High Build Wood Oil

A blend of natural oils & resins offering a transparent satin finish with exceptional durability and resistance for all external joinery & woodwork.

Produces a clear, quick drying, water repellant and weather resistant finish that will not peel or flake when applied following directions below.

Contains UV Filters and is VOC compliant.

To maintain/renovate, re-apply following guidelines below.

Preparation

Ensure all surfaces are clean, dry, and free from any previous finish. 

Remove any fungal growth, dirt or moss on old wood prior to application, and ensure a preservative has been applied. 

Sand the substrate with a medium 120 grade sanding paper or 120 grade sanding disk, removing all traces of dust. 

Application 

Apply in dry conditions. Always test on a small area prior to initial application. No primer required. Minimum 3 coats recommended. Fiddes Exterior High Build Wood Oil is formulated for application directly, and does not require thinning. 

First Coat - Stir contents thoroughly before and during use. Apply using a good quality bristle or synthetic brush and apply EVENLY and THOROUGHLY, following the direction of the grain. Leave to dry 4-6 hours in warm, dry well ventilated conditions, or preferably overnight. Sand lightly with fine 320 grade sand paper. 

Second Coat - Apply as first coat, evenly, allowing good ventilation. Leave to dry 4-6 hours in warm, dry conditions, or preferably overnight. 

Third Coat -  Apply as above. Clean applicators with White Spirit.  

Notes

Always test on a small area prior to major application.

Ensure timber is dry and has been treated with preservative

Minimum 3 coats recommended

Longer drying periods many occur during application in cold,damp or humid conditions.

Coat all areas thoroughly to seal.

Re application: To renovate previous application of Fiddes Exterior High Build Wood Oil, lightly sand area with 150 grit sandpaper and re-apply

Coverage: A single application will approximately cover 20-24 square meters per litre, depending on density of substrate. 

Packaging: 1lt - 2.5lt - 25lt Containers